Object - Modify Point Set

Parent Previous Next

Selecting Object - Modify Point Set allows you to edit the point set for an anchored parameter. This command is only enabled when one anchored parameter is selected in your circuit. This command is also available in the pop-up menu which appears when you right-click on an anchored parameter.

To modify the point set of an anchored dimension parameter, do the following:

    1. Right-click on the dimension parameter and select Modify Point Set from the pop-up menu which appears. All points in the point set are selected.
    2. To add a point, hold down the control key and click on the point you wish to add to the point set. The point is highlighted indicating its addition to the point set.
    3. To delete a point, hold down the control key and click on the highlighted point you wish to remove from the point set.
    4. When you have the desired point set selected, hit the return key.

Selecting Object ⇒ Left Point Set allows you to edit the left point set for a symmetric parameter in the x plane. This command is only enabled when one symmetric parameter is selected in your circuit. This command is also available in the pop-up menu which appears when you right-click on a symmetric parameter.

As in modifying an anchored parameter point set, you may use the normal editing commands to modify the point set.

Selecting Object ⇒ Right Point Set allows you to edit the right point set for a symmetric parameter in the x plane. This command is only enabled when one symmetric parameter is selected in your circuit. This command is also available in the pop-up menu which appears when you right-click on a symmetric parameter.

As in modifying an anchored parameter point set, you may use the normal editing commands to modify the point set.

Object ⇒ Top Point Set and Object ⇒ Bottom Point Set operate in the same manner as the Left Point Set and Right Point Set command when the symmetrical parameter is in the y plane.

To modify the point set of an anchored dimension parameter, do the following:

    1. Right-click on the dimension parameter and select Modify Point Set from the pop-up menu which appears. All points in the point set are selected.
    2. To add a point, hold down the control key and click on the point you wish to add to the point set. The point is highlighted indicating its addition to the point set.
    3. To delete a point, hold down the control key and click on the highlighted point you wish to remove from the point set.
    4. When you have the desired point set selected, hit the return key.

To modify the left point set of a symmetric dimension parameter, right-click on the symmetric parameter and select Modify Left Point Set from the pop-up menu, then continue at step 2 above.

To modify the right point set of a symmetric dimension parameter, right-click on the symmetric parameter and select Modify Right Point Set from the pop-up menu, then continue at step 2 above.

For more details about selecting and unselecting points in your geometry, see Editing Your Circuit.